![how to netboot ontap how to netboot ontap](https://www.easeus.com/images/en/screenshot/todo-backup/business/enable-network-boot.png)
Verify the status of the node members in the cluster: cluster show -epsilon * Change the privilege level to advanced, entering y when prompted to continue: set -privilege advancedī. If the system is running ONTAP, check the status of the nodes in the cluster.Ī. To shut down an impaired node, you must determine the status of the node and, if necessary, take over the node so that the healthy node continues to serve data from the impaired node storage.ġ.
![how to netboot ontap how to netboot ontap](https://docs.netapp.com/us-en/ontap-systems/media/drw_2240_x_opening_cam_latch.png)
You can shut down or take over the target controller by using different procedures, depending on the storage system hardware configuration. Removing the boot device from the controller module on page 8ġ215-08011_D Copyright © 2019 NetApp, Inc. If your system is running Data ONTAP operating in 7-Mode, you must use that procedure instead.ģ. This procedure is for systems running ONTAP. Replacing a boot device in a system running ONTAP Replacing a boot device in ONTAP involves shutting down the node, removing the old boot device, and transferring the system files to the new boot device. Replacing a boot device in a system running in 7-Mode on page 17.Replacing a boot device in a system running ONTAP on page 1.
![how to netboot ontap how to netboot ontap](https://image.slidesharecdn.com/whatisnetappsystemfirmware-130916092415-phpapp02/95/what-is-netapp-system-firmware-17-638.jpg)
The healthy node is the HA partner of the impaired node. The impaired node is the node on which you are performing maintenance. It is important that you apply the commands in these steps on the correct node:.You must use the correct procedure for your version of ONTAP 8.x. The steps for replacing a boot device in a system running 7-Mode are different from a system running ONTAP.You must replace the failed component with a replacement FRU component you received from your provider.If you experience any problems during netboot, you can verify the integrity of the files extracted from the package by comparing the md5sum values stored in the MD5SUMS file. The steps you follow to replace a boot device differ depending on whether your system is running ONTAP or 7-Mode.īefore extracting the compressed system files during the boot device installation process, you must make sure that the utility you use is set to suppress any automatic CR/LF conversions in the extracted files. The boot device stores a primary and secondary set of system files (also called the boot image) that the system uses when it boots. Version: NetApp Release 8.0.80xx systems Replacing the boot media For all operating environmentsReplacing the boot media When attempting to netboot a storage controller, the following error occurs: